- ページ 12
サーバー Dell XC6320のPDF Web-Scale ハイパーコンバージド・アプライアンス ソリューション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell XC6320 23 ページ。 Web-scale hyperconverged appliance
Dell XC6320 にも： はじめに (50 ページ)
ページを印刷する
•
Sets up vSwitch or LBFO NIC Team
•
Installs NIC drivers (Intel), Cygwin, ipmiutil, and Python
•
Registers CVM as a VM
•
Attaches Disks to CVM
•
Enables auto-start, sets the default RAM and number of vCPU for the CVM.
•
Starts CVM and checks for the existence of /tmp/svm_boot_succeeded.
•
Restarts host.
Create Nutanix storage cluster
•
Use the Nutanix web-based tool to create a Nutanix storage cluster from all locally discovered nodes that are ready to be
clustered. During this process, the following parameters are set:
– Cluster maximum Redundancy Factory (RF)
– Cluster name
– Cluster virtual IP (optional for AHV and vSphere)
– Subnet mask and default gateway (iDRAC, hypervisor and CVM)
– Domain Name Server(s) (DNS)
– Network Time Protocol (NTP) servers (hypervisor NTP N/A for Hyper-V)
– Hypervisor hostnames
– Node IPs (iDRAC, hypervisor and CVM)
– Re-installation of new hypervisor and CVM (optional with Nutanix Foundation CVM)
•
Option to create Nutanix storage cluster manually using command line interface.
NOTE: In Acropolis base (NOS) 4.5, a new web-based clustering tool called Nutanix Foundation CVM replaces the
earlier used cluster initialization page (deprecated). Nodes with Acropolis base (NOS) 4.5 or later installed in factory
uses Nutanix Foundation CVM for initial deployment while those installed with NOS prior to Acropolis base (NOS) 4.5
will continue to use the traditional cluster initialization page.
Configure Nutanix storage cluster using hypervisor management GUI
NOTE: For information about document name, see the Nutanix documentation section in the Support Matrix. The
document name varies depending on the solution software version you are running.
VMware vSphere:
•
Create storage pools through the Nutanix web console.
•
Create and mount containers as NFS datastores on appropriate hosts through the Nutanix web console.
•
Manually add and configure vSphere clusters by using the Nutanix guidelines. For more information, see the vSphere
Administration Guide.
Microsoft Hyper-V:
•
Create storage pools and containers through the Nutanix web console.
•
Run Hyper-V setup script from any CVM to join hosts to a domain, create a Hyper-V failover cluster, and register a storage
cluster as an SMB share.
•
Optionally, add a cluster to System Center Virtual Machine Manager either with the Hyper-V setup script or manually.
Default cluster credentials
The default cluster credentials for the system differ from those stated at the beginning of all Nutanix documentation. See Table 3 for
default cluster credentials, which are specific to the system.
NOTE: The default password is not set for ESXi hosts.
12