- ページ 17

モニター Dell CrystalのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell Crystal 28 ページ。 Dell crystal monitor quick setup guide
Dell Crystal にも： クイック・セットアップ・マニュアル (2 ページ)

ページを印刷する
Dell Crystal ユーザーマニュアル
 
Language
 
Menu Transparency
 
Menu Timer
 
Menu Lock
 
Button Sound
 
DDC/CI
 
LCD Conditioning
 
Factory Reset
 
OSD Warning Messagess
The following warning messages may appear on the screen to indicate that the monitor is out of synchronization.
This means that the monitor cannot synchronize with the signal that it is receiving from the computer. Either the signal is too high or too low
for the monitor to use. See Specifications for the Horizontal and Vertical frequency ranges addressable by this monitor. Recommended mode 
is 1680 X 1050 @ 60Hz.
 
If the HDMI cables are not connected, a floating dialog box as shown below appears.
Allows you to set the OSD display to one of five languages: English, Espanol, Francais, Deutsch, or Japanese.
Allows you to adjust the OSD background from opaque to transparent.
Allows you to set the time for which the OSD remains active after you press a button on the monitor.
Use the
and
buttons to adjust the slider in 1 second increments, from 5 to 60 seconds.
Controls user access to adjustments. When Lock is selected, no user adjustments are allowed. All buttons are locked except
 
NOTE:
When the OSD is locked, pressing the menu button takes you directly to the OSD settings menu, with 'OSD Lock' pre-selected on
entry. Press and hold 
button for 15 seconds to unlock and allow user access to all applicable settings.
Turns on or off the button sound.
DDC/CI (Display Data Channel/Command Interface) allows a software on your computer to adjust the monitor display settings like the
brightness, color balance etc.
Enable (Default): Optimizes the performance of your monitor and provides a better customer experience.
Disable: Disables the DDC/CI option and the following message appears on the screen.
 
Select Yes to disable DDC/CI or No to return.
LCD conditioning helps eliminate any image retention and may take several hours.
NOTE: Severe cases of image retention are known as burn-in. LCD Conditioning does not remove burn-in.
Disable: This is the default option.
Enable: Enables LCD conditioning and the following message appears on the screen. Select Yes to proceed and No to return.
 
NOTE:
Press any button on the monitor to terminate LCD Conditioning at any time.
Resets all OSD settings to the factory preset values.