- ページ 23

ストレージ Dell CONAEのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dell CONAE 36 ページ。 Direct-attach storage for poweredge serve

Figure 18. Installing a drive blank

Removing the drive carrier

Remove the drive carrier from the enclosure to replace the drive.

Prerequisites

Use the system manager software to prepare the drive for removal. If the drive is online, the green activity or fault indicator

blinks while the drive is powering off. When the drive indicators are off, the drive is ready for removal.

Steps

1. If installed,

remove the front

2. Press the release button to open the drive carrier release handle.

3. Holding the drive carrier release handle, slide the drive carrier out of the drive slot.

Figure 19. Removing a drive carrier

Removing the drive from the drive carrier

Prerequisites

Follow the safety guidelines listed in the

Steps

1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.

NOTE:

If the carrier has a Torx screw, use a Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to

remove the drive.

2. Lift the drive out of the drive carrier.

bezel.

Safety

precautions.

Replacing components