- ページ 13
モデム 3 Com U.S. Robotics 3ComのPDF ユーザーマニュアル＆リファレンスをオンラインで閲覧またはダウンロードできます。3 Com U.S. Robotics 3Com 19 ページ。 3com user's guide & reference modem 56k
ページを印刷するZn (0,1,2,3,4,5)
$
Note:
C, K commands are not implemented, will respond OK when these commands are encountered.
Ten phone numbers are stored in NVRAM.
Defaults are underlined.
Alps-specific modifications to the commands are in italics
Extended AT Command Set
&An (0,1,2,3)
&Bn
&Cn (0,1)
&Dn (0,1,2,3)
&Fn (0,1,2)
&Gn (0,1,2)
&Hn (0,1,2,3)
&In (0,1,2,3,4,5)
&Kn (0,1,2,3)
&Mn (0,4,5)
&Nn (0,1,2,3,4,5,6,7,8,
9,10,11,12,13,14,15,16)
&Pn (0,1)
&Rn (1,2)
&Sn (0,1)
&Tn (0,1,3,4,5,6,7,8)
&Un (0,1,2,3,4,5,6,7,8,
9,10,11,12,13,14,15,16)
&Wn (0,1)
&Yn (0,1,2,3)
&Zn=s (0,1,2,3)
&Zn=L (0,1,2,3)
&Zn? (0,1,2,3)
&ZL?
&$
Facsimile Commands
+FCLASS=n (0,1,2.0)
+FTS=n (0,255)
+FRS=n (0,255)
+FTM=n (3,24,48,72,73,74,
96,97,98,121,122,145,146)
+FRM=n (3,24,48,72,73,74,
96,97,98,121,122,145,146)
+FTH=n (3,24,48,72,73,74,
96,97,98,121,122,145,146)
+FRH=n (3,24,48,72,73,74,
96,97,98, 121,122,145,146)
Reset and load configuration n
AT command set help screen
ARQ result codes Enable
Unused. Will respond OK, but no action taken:
modem is always in &B1 mode.
CD Override
Data Terminal Ready signal
Load factory setting
Guard tone
Transmit flow control
Receive software flow control
Data compression
Error control
DCE link rate. (Maximum DCE link rate when
&U is not set to 0)
Make/Break ratio
Receive hardware flow control
DSR option
Diagnostic test, default is 5
DCE link rate minimum
Write current configuration NVRAM templates
Break handling
Writes phone number string s to NVRAM at position n
Writes Last executed dial string to NVRAM at position n
Displays the phone number stored at position n
Displays the last executed dial string
Extended AT command help screen
Class Identification and Control (0)
Stop Transmission and Pause
Wait For Silence
Transmit Data with Carrier
Receive Data with Carrier
Transmit HDLC Data with Carrier
Receive HDLC Data with Carrier
9