- ページ 30
ストレージ Dell EqualLogic PS SeriesのPDF ハードウェア取扱説明書をオンラインで閲覧またはダウンロードできます。Dell EqualLogic PS Series 48 ページ。 Storage arrays
Dell EqualLogic PS Series にも： セッティング (2 ページ), ハードウェア取扱説明書 (50 ページ), ハードウェア・メンテナンス (46 ページ)
ページを印刷する
PS6210 Hardware Owner's Manual
If the GUI (or CLI) still shows only one control module after appropriate time has elapsed, the
controller might not be properly installed. Try to remove the module by rotating the black lever and
reinsert the module into the array chassis. Ensure that the face of the contoller is even with the
controller already installed in the array.
After reinstalling the control module, if both control modules still do not appear in the GUI (or
CLI), contact your support provider.
If you interrupt the synchonization process, you might corrupt the control module's internal firmware,
and the control module will no longer function properly.
Replacing the MicroSD Card
Each control module includes a microSD card that contains the PS Series firmware.
If a control module fails, you will need to remove the microSD card from the failed control module
and install the card in the replacement control module. Using the card from the failed control module
ensures that the new control module is running the same firmware and configuration as the other
control module in the array.
Before you begin the procedure to replace a microSD card:
•
Review
Replacing a Control Module on page 20
control module.
•
Attach an electrostatic wrist strap, as described in
MicroSD Card Replacement Procedure
Use the following procedure for replacing the microSD card in your control module:
1. Remove the control module from the array, as described in
21.
2. Remove the SD card from the control module, as described in
page
24.
3. Install the replacement SD card in the control module, as described in
on page
25.
4. Insert the control module into the array, as described in
Removing the MicroSD Card
Callout 1 in
shows the location of the microSD card.
Figure 22
To reduce the risk of losing or damaging the microSD card, do not remove it until you are ready to
install it in the replacement control module.
1. Firmly push the card into its housing to release the spring mechanism (callout 2 in
microSD card is partially ejected from the housing.
2. Gently pull the card straight out of the housing (callout 3 in
3. Place the microSD card on a flat surface where it will be protected from electrostatic discharge.
24
3 Maintaining Control Modules
for information about removing and replacing a
Protecting Hardware on page
Removing a Control Module on page
Removing the MicroSD Card on
Inserting the MicroSD Card
Installing a Control Module on page
Figure
22).
1.
22.
Figure
22). The