- ページ 32
ストレージ Dell EqualLogic PS4100EのPDF ハードウェアマニュアルをオンラインで閲覧またはダウンロードできます。Dell EqualLogic PS4100E 50 ページ。 Equallogic ps series storage products
Dell EqualLogic PS4100E にも: 概要 (7 ページ)
–
Click Finish to complete the configuration and exit the wizard.
When you exit the wizard, it configures the group IP address as an iSCSI discovery address on the computer, if not
already present.
After you join a group, you can use the Group Manager GUI or CLI to create and manage volumes.
Computer Access To A Group
You can use the Remote Setup Wizard to enable Windows computer access to a Dell EqualLogic PS Series group. You
can also use the wizard to modify existing group access information on a computer (for example, if the group IP address
changed).
NOTE: When you create a group using the Remote Setup Wizard, computer access to the group is automatically
configured. This section applies only if you used Remote Setup Wizard on a different computer to create the group,
or created the group through the serial cable instead of Remote Setup Wizard.
When you use the Remote Setup Wizard to enable computer access to a group, the wizard performs the following:
1. Configures the group IP address as an iSCSI target discovery address. This enables the computer to discover
volumes and snapshots (iSCSI targets) in the group.
2. Stores the CHAP user name and password that allow Microsoft services (VDS or VSS) access to the group.
Enabling Computer Access To A Group
To enable computer access to a group or modify existing group access information:
1.
Obtain the following information:
–
Name and IP address of the group.
–
CHAP user name and password already configured in the group for Microsoft service (VSS or VDS) access
to the group.
NOTE: To use the Group Manager GUI to display the VSS/VDS access control record, click Group Configuration →
VSS/VDS .
NOTE: To display the local CHAP account in the group, click Group Configuration → iSCSI.
2.
Launch the Remote Setup Wizard.
3.
In the Remote Setup Wizard - Welcome window, select Configure this computer to access a PS Series SAN, and
click Next.
4.
In the Configuring Group Access dialog box, you can:
–
Click Add Group to add a group that the computer can access.
–
Select a group and click Modify Group to modify existing group access.
5.
In the Add or Modify Group Information dialog box:
a) Specify or modify the group name and IP address, as needed.
b) If the group is configured to allow Microsoft service (VDS or VSS) access to the group through CHAP, specify
the CHAP user name and password that matches the VSS/VDS access control record and local CHAP account
already configured in the group.
c) If the PS Series group is configured to restrict discovery based on CHAP credentials, click the check box next
to Use CHAP credentials for iSCSI discovery.
d) Click Save.
6.
In the Configuring Group Access dialog box, click Finish.
Configuring Multipath I/O Between A Computer And A Group
To configure multipath I/O between a computer and a group:
32