- ページ 2

ストレージ Dell PowerVault 110T SDLT320のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault 110T SDLT320 44 ページ。 User manual
Dell PowerVault 110T SDLT320 にも：ユーザーマニュアル (23 ページ)

ページを印刷する

Back to Contents Page

Cartridge Care and Cleaning: Dell™ PowerVault™ 110T SDLT 320 Tape Drive User's

Guide

• Appearance of SDLT Tapes • Cleaning the Tape Mechanism • Caring for Tape Cartridges

Appearance of SDLT Tapes

From the outside, the Super DLTtape™ cartridge looks very similar to the DLTtape IV cartridges. The basic geometry, write protection switch, and label space are unchanged

from the DLTtape IV cartridge. This simplifies the integration of Super DLTtape into existing operating environments and into automated tape libraries.

The Super DLTtape cartridge is easy to recognize; it has a different color than the DLTtape IV cartridge and contains a distinctive pattern molded into the shell. The Super

DLTtape cartridge has a keying feature to ensure you can not load it into previous generation DLTtape systems.

Cleaning the Tape Mechanism

When to Use the Cleaning Cartridge

SuperDLTtape drives do not require regular preventative cleaning due to improvements in the design. Do not clean your drive unless required. Your backup software or the

yellow Cleaning Required light (LED) notify you if you need to clean the drive. The location of the yellow Cleaning Required LED is shown in

Figure 1. Front Panel LEDs

Compatibility

The SDLT cleaning cartridge is for use in Super DLTtape drives, autoloaders, and libraries only.

Capacity

Each SDLT cleaning cartridge is good for 20 uses. Use one of the attached labels to keep track of the number of uses.

Loading a Cleaning Cartridge

To load a cleaning cartridge, follow these steps:

1. Insert the cleaning cartridge (with the front slide label slot facing outward) fully into the drive until the drive engages the cartridge and begins to take up the cleaning

media.

The green In Use light will blink and the cleaning cycle will begin automatically.

When the cleaning cycle completes the cartridge automatically ejects from the drive and the yellow Cleaning Required light shuts off.

2. Remove the cartridge, place it back into a plastic case, and mark the label after each cleaning.

NOTE: On the last cleaning, the cleaning cartridge will not eject. Use the Eject button on the front of the drive to eject the expired cleaning cartridge and dispose of

the cartridge.

For additional details about using cleaning cartridges in autoloaders and libraries, refer to the owner's manual for that product.

Cleaning Cartridge Care

Drive

Density

LED

(Amber)

Drive

Status

LED

(Green)

Cleaning

Required

LED

(Yellow)

Eject

Button

Figure