- ページ 18

ストレージ Dell PowerVault DX6104のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault DX6104 39 ページ。 Dx object storage platform
Dell PowerVault DX6104 にも：スタートマニュアル (8 ページ), スタートマニュアル (10 ページ), マニュアル (37 ページ), リリースノート (16 ページ), マニュアル (12 ページ), マニュアル (24 ページ), マニュアル (23 ページ)

NOTE: The DX Storage Node is preconfigured to network boot from the DX Cluster Services Node. The

network ports must be connected to the private network before the system is turned on.

Installing The System In A Rack

If the DX system includes a rail kit, locate the

instructions to install the rails in the rack unit and to install the DX system in the rack.

Getting Started Guide that shipped with your system and follow the instructions to attach the power and

Locate the

network cables to the DX system. Connect the network ports to the cluster's private network on the same IP subnet as

the other storage nodes. The DX Storage Node is preconfigured to network boot from the DX Cluster Services Node and

the NIC ports are preconfigured in balanced-alb modes.

After cabling the storage node, turn it on, and verify that the network boot is successful.

NOTE: If the network boot is not successful, verify that the cables are correctly connected to the private network.

The DX Storage Cluster capacity is licensed. To expand the cluster capacity, you must purchase a capacity license. On

purchasing a capacity license, you receive a capacity license card that contains an activation code. Enter the activation

code in the DX Cluster Services console to enable the additional cluster capacity.

NOTE: The capacity is only applicable to the cluster in which it is entered.

To activate additional cluster capacity, follow the instructions in the

Configuration Guide .

You can add additional network adapters to the DX Storage Nodes to expand the network bandwidth to the storage

nodes.

To add additional network adapters:

Turn off the DX Storage Node.

To add a network adapter, follow the steps in the DX Storage Node's

Connect the Ethernet ports to the private network.

See the figure in

Adding Network Adapters to DX Cluster Services

Turn on the DX Storage Node.

The DX Storage Node is automatically configured with all network ports bonded.

Rack Installation Instructions supplied with the rail kit. Follow the

Cluster Services Node Installation and

Nodes.

Owner's Manual at dell.com/support/manuals.