- ページ 7

ストレージ Dell PowerVault LTO4-120のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault LTO4-120 26 ページ。 Powervault tape systems
Dell PowerVault LTO4-120 にも：スタートマニュアル (33 ページ), ハンドブック (28 ページ), ユーザーマニュアル (44 ページ)

ページを印刷する

Loading a Tape Cartridge

To load an Ultrium tape cartridge into the Dell PowerVault LTO-4-120 Half-Height tape drive, perform the following steps:

1. Insert the cartridge into the slot.

2. Push the cartridge further into the drive until the drive senses the cartridge and automatically completes the load operation.

Alternatively, use a library or host command to complete the host operation.

Unloading a Tape Cartridge

To unload an Ultrium tape cartridge from the Dell PowerVault LTO-4-120 Half-Height tape drive, either:

Use a library or host command to unload the tape.

Press the Eject button on the front panel of the drive.

CAUTION:

After you press the Eject button, several minutes can elapse before the drive ejects the cartridge. Do not power down the tape drive or

the host computer until the drive has completely ejected the cartridge.

Write Protecting a Tape Cartridge

Ultrium tape cartridges have a sliding write-protect switch at the right-rear corner as shown in Figure 4-2.

Sliding the write-protect switch toward the . . .

center of the cartridge (the Locked position),

corner of the cartridge (the Unlocked position),

Figure 4-2. Ultrium Tape Cartridge Write-Protect Switch

Tape Cartridge Care and Maintenance

Observe the following precautions to protect the data on your Ultrium tape cartridges:

Always:

Do not:

Cleaning the Tape Drive

Excessive tape debris or other material can accumulate on the tape heads if the drive is:

Enables data to be . . .

read from the cartridge, but not written to it. (This is the write-protected

position.)

both read from and written to the cartridge. (This is the write-enabled

position.)

Remove the cartridge from the drive when not in use and store it in its protective case.

Avoid dropping the cartridge. This can damage components inside the cartridge, possibly rendering the tape

unusable. If you drop a tape cartridge, open the cartridge door and make sure that the leader pin is in the

correct position.

Re-tension a dropped cartridge before using.

Keep the cartridge away from:

Direct sunlight and heat sources, such as radiators, heaters, or warm air ducts.

Sources of electromagnetic fields, such as telephones, computer monitors, dictation equipment,

mechanical or printing calculators, motors, magnetic tools, and bulk erasers.

Expose the cartridge to dirt, dust or moisture.

Touch the tape media within the cartridge.

Bulk erase Ultrium tape cartridges. LTO tape cartridges have prewritten servo patterns that cannot be

reformatted by the tape drive. A bulk erase operation would make them unusable.

Use tape cartridges outside the specified operating conditions: 10° C to 45° C, 10% to 80% relative

humidity.

If a tape cartridge has been exposed to conditions outside the specified range, recondition the tape before

using in the operating environment by exposing it to the operating environment for a time equal to or

greater than the time it was outside the operating environment, up to a maximum of 24 hours. Then re-

tension the tape to stabilize the tape pack for better performance.

Get other manuals https://www.bkmanuals.com