- ページ 9

ストレージ Dell PowerVault MD3200i SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault MD3200i Series 46 ページ。 Storage arrays
Dell PowerVault MD3200i Series にも：配備マニュアル (41 ページ), 更新マニュアル (32 ページ), ラック取り付け説明書 (2 ページ), サポート・マトリックス (12 ページ), インストレーション・マニュアル (18 ページ), 情報更新 (1 ページ), サポート・マトリックス (11 ページ), サポート・マトリックス (17 ページ), テクニカルマニュアルブック (38 ページ), ホワイトペーパー (22 ページ), マニュアル (16 ページ)

11 The installation is now complete. Click Done to close the installation

wizard.

NOTE:

To verify successful installation of the application server, run services.msc,

and verify that the cimserver service has been installed and has started along with

the Jetty6-Service service. Also note that after the application server has been

rebooted, the name of the CIMOM service will change to Pegasus CIM Object

Manager.

Application and vCenter Server Configuration

After the application server has been installed, verify the Dell Storage

vCenter Plug-In has been successfully registered with the vCenter server.

Open a vSphere Client to the vCenter Server, and select Plug-insManage

Plug-ins. You should see the Dell Storage vCenter Plug-In listed as enabled. If

it is listed as disabled with an error message stating that it cannot

communicate with the application server, verify that the port number defined

for the Jetty server is enabled to pass through any firewalls that may be in use.

The default Jetty TCP port number is 8084 and 8081.

After the application server and vCenter server have been configured, you

should now see the Dell Storage vCenter Plug-in icon on the home page of

the vSphere Client under the Solution and Application section as shown in

Figure 2.

Dell MD Storage Array vCenter Plug-in