- ページ 21

ストレージ Dell PowerVault MD3620fのPDF 配備マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault MD3620f 36 ページ。 Remote replication
Dell PowerVault MD3620f にも：設定マニュアル (22 ページ), インストレーション・マニュアル (18 ページ), サポート・マトリックス (17 ページ), 機能マニュアル (15 ページ)

Post Installation Tasks

Before using the PowerVault MD3600f Series storage array for the first time,

complete a number of initial configuration tasks in the order shown. These

tasks are performed using the MD Storage Manager (MDSM) software.

1 For out-of-band management, you must set the network configuration for

each RAID controller module, including its Internet Protocol (IP) address,

subnetwork mask (subnet mask), and gateway.

NOTE:

You can set the network configuration using a DHCP server.

2 Start MDSM.

•

On Microsoft Windows operating systems, click StartPrograms

DellMD Storage ManagerModular Disk Storage Manager

Client.

On Linux operating systems, click the MD Storage Manager desktop

•

icon. You can also launch MD Storage Manager in Linux by running

the following commands at the command prompt:

/opt/dell/mdstoragesoftware/mdstoragemanager/c

lient

./SMclient

3 In the Enterprise Management Window (EMW), go to Setup Add

Storage Array and start the automatic discovery of systems.

NOTE:

Only storage arrays configured with IP address on the same subnet as

the management stations will be detected.

NOTE:

It may take several minutes for the discovery process to complete.

Closing the Automatic Discovery Status window before this stops the

discovery process.

After discovery is complete, a confirmation screen appears.

Post Installation Tasks