- ページ 6

ストレージ Dell PS4110のPDF ハードウェア取扱説明書をオンラインで閲覧またはダウンロードできます。Dell PS4110 48 ページ。 Storage arrays
Dell PS4110 にも：ユーザーマニュアル (20 ページ), ハードウェアマニュアル (50 ページ), 概要 (7 ページ), インストール (2 ページ)

ページを印刷する

1. Replacing a Control Module

Hardware Owner's Manual

Protecting Hardware

Protect a PS Series array from electrostatic discharge. When handling array hardware, make sure you use an

electrostatic wrist strap or a similar form of protection. To use a wrist strap:

1. Connect the steel snap on the coil cord to the stud on the elastic band. See

2. Fit the band closely around your wrist.

3. Connect the band to ground. You can either plug the banana connector into a matching grounded receptacle,

or attach it to the matching alligator clip and connect the clip to a grounded device. Examples of an appro-

priate ground would be an ESD mat or the metal frame of a grounded piece of equipment.

Chassis Types

The PS4110 array is available in two different chassis types:

•

A 2U chassis with 24 2.5-inch drives, installed vertically

•

A 2U chassis with 12 3.5-inch drives, installed horizontally

Array Features

The array has LEDs and other features on both the front and the back.

The Bezel

The bezel is an optional trim panel that attaches to the front of the array to ensure the physical security of the

array. You must remove the bezel to access and maintain the drives.

The bezel has a label that identifies the array model number.

Figure 1: Using an Electrostatic Wrist Strap

1 Basic Storage Array Information

Figure