- ページ 29

ストレージ Dell S3124のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell S3124 45 ページ。
Dell S3124 にも：スタートマニュアル (27 ページ)

Storing Components

If you do not install your system and components immediately, Dell Networking recommends properly storing the system and all

optional components until you are ready to install them.

Follow these storage guidelines:

● Storage temperature must remain constant ranging from –40° to 158°F (–40° to 70°C).

● Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning ducts.

● Store in a dust-free environment.

WARNING:

ESD damage can occur when components are mishandled. Always wear an ESD-preventive wrist or

heel ground strap when handling the system and its accessories. After you remove the original packaging, place

the system and its components on an antistatic surface.

NOTE:

If you do not install all components, verify that protective covers on the chassis are in place.

To install a power supply, follow these steps.

CAUTION:

Remove the power cable from the power supplies prior to removing the power supply module itself.

Power must not be connected prior to insertion in the chassis.

CAUTION:

To prevent electrical shock, ensure that the system is grounded properly. If you do not ground your

equipment correctly, excessive emissions may result. To ensure that the power cables meet your local electrical

requirements, use a qualified electrician.

WARNING:

ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel

ground strap when handling the system and its components.

NOTE:

The PSU slides into the slot smoothly. Do not force the PSU into a slot as this may damage the PSU or the chassis.

Ensure that you install the PSU correctly. When you install the PSU correctly, the power connector is on the right side of

the PSU.

NOTE:

The PSUs are field replaceable. When running with full redundancy (two power supplies installed and running), you

can remove and replace one PSU while the other PSU is running, without disrupting traffic.

1. Remove the PSU slot cover from the PSU side of switch. You can select either of the two PSU slots, however, if you are

using a single PSU, Dell Networking recommends using power supply 1 (PSU1) as the blank plate slot.

2. Remove the PSU from the electrostatic bag.

3. Insert the PSU into the switch PSU slot (insert the PSU-exposed PCB edge connector first). The PSU slot is keyed such

that the PSU can only be fully inserted in one orientation.

4. Plug in the AC cord from the switch PSU to the external power source, such as an AC wall outlet.

NOTE:

The system powers up as soon as the cables are connected between the power supply and the power source. If

you have not yet installed the switch in a rack, defer this step until you are ready to power up the system.

5. If you have a redundant PSU (a second PSU), repeat steps 1 through 4 using the second PSU slot on the S3100 series

system.

6. If you use a single PSU, install a blank plate in the other PSU slot.

Install a S3100 Series System