- ページ 6

ウィンドウ・ブラインド 3 Day Blinds Faux Wood 1のPDF はじめにをオンラインで閲覧またはダウンロードできます。3 Day Blinds Faux Wood 1 6 ページ。

HOLD DOWN BRACKETS

Hold down brackets are used primarily on shades being

mounted to doors or in motor homes. (2 per blind) Hold

Down Brackets are available by contacting our Client Care

Team at 800-800-3329. There is a small hole in the center of

the end cap that is covered by a thin plastic cover. Use the

pin of the hold down bracket to push through the center of

the end cap and it will break through the plastic cover.

• With the blind lowered to its full length, place the pin of

each hold down bracket into the hole in each end of the

bottom rail.

• Using a pencil, mark the mounting surface through the holes

in the hold down bracket. Make sure the hold down brackets

are level and aligned with each other.

• Raise the blind and screw the hold down brackets into the

mounting surface using the screws provided.

• Mount the hold down to the side or back of the window

frame so that the pin lines up with the front hole in the

ottom rail end cap with the blind fully lowered.

| 1" Faux Wood Blinds

• Lower the shade and

flex the hold down

bracket outward so

that the pin can be

inserted into the hole

in the end cap.

WARNING

Young children can STRANGLE in cord and bead chain loops.

They can also wrap cords around their necks and STRANGLE.

• Always keep cords and bead chains out of children's reach.

• Move cribs, playpens, and other furniture away from cords

and bead chains. Children can climb furniture to get to cords.

• Do not tie cords together. Make sure cords do not twist

together and create a loop.

Inner cords can pull out to form a loop, which can strangle a

young child.

• Inner cord stop devices can reduce this risk if positioned

correctly on the pull cords.

• If inner cord stop devices are more than 3 in (76 mm) below

the headrail when the blind is fully lowered, move them

closer by following the inner cord stop device adjustment

instructions.

800-800-3329 | 3dayblinds.com

ANSI/WMCA A100.1-2012 5.2.1

3˝ or less

ANSI/WMCA A100.1-2012 5.3.1.1