- ページ 10
スイッチ Dell 3WY51のPDF ファームウェアのアップグレード方法をオンラインで閲覧またはダウンロードできます。Dell 3WY51 17 ページ。 Emcnetworking switches
- 1. Table of Contents
- 2. Introduction
- 3. Global Support
- 4. Firmware Upgrade Overview
- 5. Firmware Downgrade Overview
- 6. How to Access Serial Console on Dell EMC Networking N1500 Series Switches
- 7. Upgrade Example of Dell EMC Networking N1500 Series Switches
- 8. Upgrade Stack of Dell EMC Networking N1500 Series Switches
- 9. Switch Recovery Procedure
- 10. Switch Recovery Example
- 11. End of Document
Upgrade Dell EMC Networking N1500 Series Switches
<185> Aug 21 02:06:43 0.0.0.0-1 SIM[Cnfgr_Thread ]: sim_util.c(3786) 9 %% Switch was reset
due to operator intervention.
(Unit 1 - Waiting to select management unit)>
Applying Global configuration, please wait ...
Applying Interface configuration, please wait ...
console>
7. On Completion of switch reboot, login and verify that the firmware has been updated to the
version using the show version command. Reboot process may take around two minutes for a switch,
whereas for stack of switches it may take significantly longer time.
console#show version
Machine Description............... Dell EMC Networking Switch
System Model ID................... N1524
Machine Type...................... Dell EMC Networking N1524
Serial Number..................... 14C24M0030LF
Manufacturer...................... 0xbc00
Burned In MAC Address............. 001E.C9E5.BA2F
System Object ID.................. 1.3.6.1.4.1.674.10895.3063
SOC Version....................... BCM56150_A0
HW Version........................ 1
CPLD Version...................... 16
Image File........................ N1500v6.5.2.9
Software Capability............... Stack Limit = 4, VLAN Limit = 512
unit
active
----- ------------ ------------ ----------------- -----------------
1
6.5.2.9
8. Switch is now ready for normal operation. Verify the configuration and make any changes needed prior to
connecting the switch to a operational network.
9. After the switch has finished rebooting, log in and update boot-code using the update bootcode command
from CLI and then perform reload for the new boot-code to take effect.
console#update bootcode
console#reload
10. On switch reload, verify the boot-code version is updated to the latest "
g9552470cd8 (Feb 20 2018 - 15:54:29)
backup
current-active
6.3.3.14
6.5.2.9
"
from the serial console.
Page 8
next-active
6.5.2.9
U-Boot 2012.10-00244-
6.5.2.9