- ページ 33

スイッチ Dell Aruba 650のPDF 補足マニュアルをオンラインで閲覧またはダウンロードできます。Dell Aruba 650 42 ページ。 Controllers with arubaos fips firmware non-proprietary security policy fips 140-2 level 2 release supplement

ページを印刷する

The tamper-evident labels shall be installed for the module to operate in a FIPS Approved mode of operation.

Reading TELs

Once applied, the TELs included with the switch cannot be surreptitiously broken, removed, or reapplied

without an obvious change in appearance:

Figure 1 Tamper-Evident Labels

Each TELs also has a unique serial number to prevent replacement with similar labels.

Required TEL Locations

Aruba 620

This sections displays all the TEL locations on the Aruba 620. The Aruba 620 requires a minimum of 8 TELs

to be applied as follows:

To detect opening of the chassis cover:

1. Spanning the front face plate and left and bottom chassis cover

2. Spanning the front face plate and top chassis cover

3. Spanning the front face plate and bottom chassis cover

4. Spanning the front face plate and right and bottom chassis cover

5. Spanning the front face plate and right and bottom chassis cover

6. Spanning the front face plate and top chassis cover

7. Spanning the front face plate and bottom chassis cover

8. Spanning the front face plate and left and bottom chassis cover

To detect access to restricted ports:

3. Spanning the Express Card slot

7. Spanning the seriel port

Aruba 620, 650 and Dell W-620, W-650 | FIPS 140-2 Level 2 Release Supplement

Installing the Controller |