- ページ 12

スイッチ Dell C7004のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dell C7004 27 ページ。 Systems

(SERIES CB)) line cards are interchangeable between the C7008/C300 and

C7004/C150 only if the chassis is running Dell Networking OS version

7.6.1.0 or later.

•

To control airflow for adequate system cooling, personal safety, and EMI

containment during operation, blanks are required in empty slots. Yoou must

install all chassis slots with operational modules or blanks. Always replace

cards and blank panels immediately.

Installing RPMs and Line Cards

WARNING: Always wear an ESD-preventive wrist or foot-heel ground strap

when handling RPMs or line cards. Place RPMs and line cards on an antistatic

surface when they are not installed. ESD damage can occur when components

are mishandled.

CAUTION: Unlock the levers before inserting the line card into the chassis.

Fully engage the locking mechanism after the card has been inserted; not

doing so might damage the card below it when you insert that lower card.

NOTE: The fan tray face panel has slot number markings for the RPMs and line

cards. To simplify RPM and line card installation, insert the fan tray before the line

cards.

Step

Task

Extend the left and right card levers by first pressing gently down on the

thumb tabs in the ejector levers and then pulling the ejector levers

simultaneously until they are in the open position.

Hold the card assembly by the metal carrier edges. Avoid touching the

printed circuit board and connector pins.

Align the card with the guide, and gently slide it into any line card slot

until the card is about halfway into the slot.

Continue sliding the card until you feel the connectors engage with the

chassis backplane.

Installing the Hardware

NOTE: To determine which slots are for the RPMs and which are

for the line cards, use the markings on the fan tray.