- ページ 17

室内装飾品 Earthlite Ellora Flat TopのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Earthlite Ellora Flat Top 20 ページ。 Electric lift table

ページを印刷する

If a foot glide leveler becomes damaged or is need of replacement, carefully follow these next steps.

We recommend that at least two (2) people conduct steps 1 & 5.

Step 1

Unplug the table and carefully

lean the table on its side opposite

the foot glide leveler in need of

replacement (Diagram A).

Step 4

Attach the new foot glide leveler

to the metal ball joint and push.

The Foot glide leveler will snap

into place (Diagram D).

This helpful troubleshooting guide will provide you with information about how to recognize a problem

with your Ellora™, determine possible causes, and find a solution. In the event your specific situation is not

covered in this guide, please contact Earthlite at 800-872-0560 or 760-599-1112 so our technical support

department can assist you.

Our Customer Service Representative will ask you to provide the following information:

a) Your table's serial number (located on the underside of the head section of the table top

b) Description of the problem

Problem

My table is wobbling and

moving from side to side.

Table top won't rise or lower.

Pneumatic hand lever or finger

lever seems stuck

Where can I find my table

number?

My table is making noise when

going up and down.

My table is making a clicking

noise and it's not going up

or down.

My table is not going up or

down and it's not making

any sound.

REPLACING A FOOT GLIDE LEVELER

Step 2

Locate the damaged foot glide

leveler in need of replacing

which is attached to its metal

ball joint (Diagram B).

Step 5

Carefully return the table

back to its upright position

(Diagram E).

Probable Cause

The table is not level with

the floor.

Cables might be caught or

tangled.

The customer might be

looking on the motor.

The center bolt that

connects the legs

together is too tight.

The control box is not relaying

the signal from the foot pedal

to the actuator.

Foot pedal is not relaying

signal to the control box.

Step 3

Remove the damaged foot glide

leveler by pulling it directly off the

metal ball joint (Diagram C).

We recommend at least two (2)

people lay the table on its side

before conducting step 1 & 5. Lay

a towel or blanket down under the

table, before resting the table on

its side to protect the upholstery.

TROUBLESHOOTING

Adjust one or both of the foot

glide levers until the table

becomes level with the floor

and is stable.

Check to see that all the

cables are free and not

caught on any brackets.

The table number is located on

underside of the table, near head

section on a white label. It will read

'SNT' followed by a 6 digit number.

Remove the plastic cap covering

the center bolt and loosen the

bolt one half to one full turn.

Replace the control box.

Replace the foot pedal.

Solution