- ページ 9

スイッチ Dell Force 10のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force 10 29 ページ。 Implementing fcoe in the linux operating system

Implementing FCoE in the Linux Operating System

7. On the Cisco Nexus 5020 distribution switch, make sure that the FCoE VLAN is created and

associated to the appropriate Virtual SAN (VSAN) by running the following from the switch

command line:

interface vlan 255

FCOE vsan 255

no shut

8. On the distribution switch; make sure that the appropriate native VLAN for that interface is set

up as seen below:

interface Ethernet 1/12

switchport mode trunk

switchport trunk native vlan 46

switchport trunk allowed vlan 46,255

9. Bind the FCoE-FIP MAC address of the server's network interface adapter. You can get the

server's MAC address from the CMC by navigating to Server -> Setup ->FlexAddress from the

CMC management GUI. Be aware of what port your server is on and what side of the fabric

your server is on (for example: Fabric A side 2). You bind this address on the Cisco 5020

distribution switch that is running NPIV mode by running the following commands from the

switch command line:

interface vfc XX

bind mac-address a4:ba:db:49:d0:17

no shutdown

10. The last thing to do on the distribution switch is to place the newly created VFC into the

proper VSAN database while in global configuration mode. To do this, run the following

commands from the distribution switch command line:

VSAN database

VSAN 255 interface vfc 50

11. On the Dell Force10 MXL 10/40GbE (edge) switch, verify that an FCoE connection was

established. To do this, run the following command on the edge switch command line while in

EXEC mode; see Figure 2 for sample results:

show fip-snooping enode

(creates the VLAN)

(defines the VLAN as FCoE, and then associates it to VSAN 255)

(turns on the VLAN)

(notice that the appropriate FCoE VLAN is

also allowed, VLAN 255)

(this creates a Virtual Fibre Channel (FVC) interface; XX is any

number id that is available)

(binding FCoE-FIP MAC Address)

(this turns on the interface)

(enter VSAN definition/configuration mode)

(VFC 50 being placed into VSAN 255)