- ページ 12

スイッチ Dell Force10 MXL 10 GbEのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 MXL 10 GbE 27 ページ。 10/40gbe blade switches
Dell Force10 MXL 10 GbE にも：スタートマニュアル (38 ページ)

ページを印刷する

1. Restoring Factory Defaults

Stacking Dell Force10 MXL 10/40G Switches

Current Type

Master priority : 0

Hardware Rev

Num Ports

Up Time

FTOS Version

Jumbo Capable : yes

POE Capable

Burned In MAC : 00:1e:c9:cc:bb:21



No Of MACs

To force a particular switch to become the Master during stack creation, be sure that switch has the

highest Priority of all switches joining the stack. The switch with the highest Priority number is

elected Master. The default Priority is 0. Priorities for the stack-unit can be configured using the

command 'stack-unit <unit-number> priority <1-14>' from the configuration mode as follows:

FTOS(conf)#stack-unit 0 priority ?

<1-14>

FTOS(conf)#stack-unit 0 priority 12

Stacking scenarios

The following section presents a variety of examples stacking Dell Force10 MXL switches, providing

step-by-step CLI commands. Consult the table of contents for a list of examples covered in this

document.

It is most important to have all switches on the same firmware version prior to stacking them. Be sure

to update all switches to be used with the latest firmware to obtain the best results.

Unless noted, the example scenarios assume the switches are using the MXL built-in external ports 33

and 37 and that no expansion modules are installed providing additional external ports. However, once

a QSFP+ expansion module is set to 40Gb mode, it can then be set to stacking mode just like the built-

in QSFP+ ports. Each QSFP+ expansion module (Figure 2) installed provides two additional ports which

can be used for stacking when in 40Gb port mode. Use the "show system stack-port" command to see

if any ports are already in stacking mode.

source not found.Error! Reference source not found.

Figure 4.

Dell Force10 MXL modular blade switches may only be stacked using QSFP+ ports in 40GbE port mode.

QSFP+ built-in ports are set to 40Gb by default while expansion module QSFP+ ports are set to 10Gb

ports by default. To change a port from 10Gb mode to 40Gb mode, use the command

: MXL-10/40GbE - 34-port GE/TE/FG (XL)

: X00

: 56

: 1 wk, 3 day, 23 hr, 5 min

: 8.3.16.0E0

: no

: 3

Priority Value

Error! Reference source not found.Error! Reference

QSFP+ two 40GbE port expansion for the MXL