- ページ 16

スイッチ Dell Force10 S4810のPDF 配備マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S4810 36 ページ。 Dell force10 s4810 switch
Dell Force10 S4810 にも：クイック・スタート・マニュアル (27 ページ), 設定マニュアル (17 ページ), 設定マニュアル (17 ページ)

ページを印刷する

Packets: -, Bytes: -

Match Parameters:

Valid Match: Etype,DMAC,DIP

In Port

: *

SMAC

: *

VLAN id

: *

IP TOS

: *

Src IP

: *

Src Port

: *

Actions:

Set SMAC: 00:01:e8:8b:1a:32

Set DMAC: 00:00:00:00:00:11

Output: Te 0/31

The following example shows the sample L3 flow in of-instance 2 transmitting packets from the OF VLAN port Te 0/1:

FTOS#show openflow flows of-instance 2

Instance: 2, Table: route, Flow: 3, Cookie: 0xffffffffa4cb6a2e

Priority: 32768, Internal Priority: 0

Up Time: 0d 00:00:11, Hard Timeout: 0 seconds

Idle Timeout: 0 seconds, Internal Idle Timeout: 0 seconds

Packets: -, Bytes: -

Match Parameters:

Valid Match: Etype,DMAC,DIP

In Port

: *

SMAC

: *

VLAN id

: *

IP TOS

: *

Src IP

: *

Src Port

: *

Actions:

Set VLAN id: 200

Set SMAC: 00:01:e8:8b:1a:32

Set DMAC: 00:00:00:00:00:22

Output: Te 0/1

For complete L3 flow formats, refer to

L2 Flows

L2 flows are only supported on OF VLANs. In the following example, of-instance 2 is used to demonstrate an L2 flow. To

use the L2 flow table, you must enable the multiple-fwd-table and flow-map l2 commands, as shown below.

If you do not enable either command , L2 flows are added to the ACL table.

FTOS#show running-config openflow of-instance 2

openflow of-instance 2

controller 1 10.11.205.184

flow-map l2 enable

flow-map l3 enable

interface-type vlan

learning-switch-assist enable

multiple-fwd-table enable

no shutdown

The example below demonstrates a sample flow in of-vlan 200:

FTOS#show openflow flows of-instance 2

Instance: 2, Table: mac, Flow: 4, Cookie: 0xffffffffac2dbbf2

Priority: 32768, Internal Priority: 0

Up Time: 0d 00:00:09, Hard Timeout: 0 seconds

EType

: ip

DMAC

: 00:01:e8:8b:1a:32

VLAN PCP

: *

IP proto

: *

Dest IP

: 1.1.1.0/24

Dest Port : *