- ページ 11

スイッチ Dell Force10 S4810のPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S4810 17 ページ。 Dell force10 s4810 switch
Dell Force10 S4810 にも：クイック・スタート・マニュアル (27 ページ), 配備マニュアル (36 ページ), 設定マニュアル (17 ページ)

ページを印刷する

Configure Data Center Bridging (DCB) (Optional)

To enable DCB mode on the switch, use the following commands.

Note: You must complete the Dell recommended switch configuration steps in sections 2.1 to 2.12

before configuring the switch for DCB mode.

3.1

Disable 802.3x flowcontrol on SFP+ ports

FTOS#configure

FTOS(conf)#interface range tengigabitethernet 0/0 - 47

FTOS(conf-if-range-te-0/0-47)#no flowcontrol rx on tx off

3.2

Disable 802.3x flowcontrol on QSFP ports

FTOS#configure

FTOS(conf)#interface range fortyGigE 0/48 – 60

FTOS(conf-if-range-fo-0/48-52)#no flowcontrol rx on tx off

3.3

Create tagged VLAN for all ports and port-channels

FTOS#configure

FTOS(conf)#interface vlan vlan-id

Note: You must supply a VLAN id. The valid range is 2-4093.

FTOS (conf-if-vl-vlan-id*)#tagged tengigabitethernet 0/0-47

FTOS (conf-if-vl-vlan-id*)#tagged port-channel 1

3.4

Configure priority groups and policies

FTOS#configure

FTOS(conf)#dcb-input pfc

FTOS(conf-dcb-in)#pfc priority 4

FTOS(conf-dcb-in)#exit

FTOS(conf)#priority-group iSCSI

SCG1000

Force10 S4810 Configuration Guide