- ページ 14

スイッチ Dell Force10 S4810のPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S4810 17 ページ。 Dell force10 s4810 switch
Dell Force10 S4810 にも：クイック・スタート・マニュアル (27 ページ), 配備マニュアル (36 ページ), 設定マニュアル (17 ページ)

ページを印刷する

Reverting from DCB to non-DCB configuration (Optional)

One method to revert from a DCB configured switch to a non-DCB configured switch is to delete the

current configuration (startup-config) and follow the steps in Section 2. If deleting the current

configuration is not an option, then use the following procedure to unconfigure DCB and enable standard

flow control.

Note: This is a disruptive operation that will require down time. The arrays will temporarily lose

communication with each other. Power off all arrays and hosts connected to the SAN before proceeding

with these steps.

4.1

Disable DCB

FTOS#configure

FTOS(conf)#no dcb enable

FTOS(conf)#no dcb stack-unit all pfc-buffering pfc-ports 56 pfc-queues 2

FTOS(conf)#exit

4.2

Remove DCB policies and apply standard flow control

FTOS#configure

FTOS(conf)#interface range tengigabitethernet 0/0 - 47

FTOS(conf-if-range-te-0/0-47)#no dcb-policy input pfc

FTOS(conf-if-range-te-0/0-47)#no dcb-policy output ets

FTOS(conf-if-range-te-0/0-47)#flowcontrol rx on tx off

FTOS(conf-if-range-te-0/0-47)#exit

FTOS(conf)#interface range fortyGigE 0/48 - 60

FTOS(conf-if-range-fo-0/48-60)#no dcb-policy input pfc

FTOS(conf-if-range-fo-0/48-60)#no dcb-policy output ets

FTOS(conf-if-range-fo-0/48-60)#flowcontrol rx on tx off

FTOS(conf-if-range-fo-0/48-60)#exit

SCG1000

Force10 S4810 Configuration Guide