- ページ 29
スイッチ Dell Force10 S60 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S60 Series 45 ページ。
Dell Force10 S60 Series にも： クイック・スタート・マニュアル (29 ページ)
ページを印刷する
Access the RJ-45 Console Port with a DB-9 Adapter
If the DTE has a DB-9 interface, you can connect to the console port using an RJ-45 to DB-9 adapter
along with the RJ-45 rollover cable.
Table 6-1. Pin Assignments Between the E-Series Console and a DTE Terminal Server
E-Series Console
Port
Signal
RTS
NC
TxD
GND
GND
RxD
NC
CTS
Access the USB-B Console Port
The S60 system has two management ports available for system access: a console port and a Universal
Serial Bus (USB)-B port
settings are the same. When the USB-B drive is connected, the S60 system sends all messages to it.
The USB-B connector port is labeled on the left of the management ports on the rear of the S60 system.
Figure 6-2. S60 USB-B Port Connector
When you connect both the console port and the USB-B port, the S60 system defaults to the USB-B port.
If the USB-B port is connected, the console connection is considered inactive.
NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on
your PC. You will also require the appropriate drivers for the USB device in use. For assistance, contact Dell
Networking Technical Support.
Table 6-1
RJ-45 to RJ-45 Rollover Cable
RJ-45 Pinout
RJ-45 Pinout
1
2
3
4
5
6
7
8
(Figure
6-2). The USB-B ports act exactly as the console port. The terminal
lists the pin assignments.
RJ-45 to DB-9
Adapter
DB-9 Pin
8
7
6
5
4
3
2
1
USB-B
Port
Terminal Server Device
Signal
8
CTS
6
DSR
2
RxD
5
GND
5
GND
3
TxD
4
DTR
7
RTS
Access the Console Ports
|
29