- ページ 21
スイッチ Dell PowerConnect 7048R-RAのPDF リリースノートをオンラインで閲覧またはダウンロードできます。Dell PowerConnect 7048R-RA 27 ページ。 Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 7048R-RA にも： ファームウェアのアップグレード (24 ページ)
ページを印刷する
PowerConnect M6220/M6348/8024/8024F/M8024/M8024-k/
7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes
Summary
CDP (ISDP) is active on port-channels
instead of the member Ethernet
interfaces. For dynamic LAGS, the ISDP
information is not exchanged on the
interface until the port-channel becomes
active.
CLI Manual Has No Index
Script validation is fails when max SNTP
servers are configured.
Configured SYSLOG server parameters
cannot be updated without deleting and
re-configuring
CLI will not let user configure available
parameter for the given IGMP command
Inconsistent behavior - using same port
number for multiple services
LLDP Assignment of port ID for Port-
Description TLV
Management ACL list needs "Match every
packet" option
SNMP support for Dell-LAN-TRAP-MIB
System Firmware Version 4.1.0.6
User Impact
User confusion over switch
operations. Inability to interoperate
with other switches.
User frustration over switch
configuration.
User confusion over switch
configuration.
User frustration over switch
configuration.
User frustration over switch
configuration.
User confusion over switch
operations.
User confusion over switch
operations. Inability to diagnose
network issues.
User frustration over switch
configuration. Possible security
issue.
User frustration over switch
configuration.
Workaround
CDP is active on the member ports for
dynamic LAGs when the LAG is active.
The CLI manual has an index
Corrected CLI validation check so that
existing server can be entered multiple
times.
Syslog server parameter can be updated in
the CLI without deleting the server
IGMP configuration commands can be
entered in interface VLAN mode at any
time
Attempting to add a service with a TCP
port overlapping a TCP port used by an
existing service is denied with an
appropriate error message.
The LLDP port id TLV is supported by
PowerConnect and can be displayed on
peer devices
New syntax has been added to the
management ACL to allow the any
specification for the service type.
The Dell-LAN-TRAP-MIB is supported
Page 19