- ページ 10
スイッチ Dell PowerConnect 7048R-RAのPDF ファームウェアのアップグレードをオンラインで閲覧またはダウンロードできます。Dell PowerConnect 7048R-RA 24 ページ。 Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 7048R-RA にも： リリースノート (27 ページ)
ページを印刷する
Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or
4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware
- # of sectors per FAT copy:
- # of FAT table copies:
- # of hidden sectors:
- first cluster is in sector #
- Update last access date for open-read-close = FALSE
PCI unit 0: Dev 0xb820, Rev 0x11, Chip BCM56820_B0, Driver BCM56820_A0
SOC unit 0 attached to PCI device BCM56820_B0
Adding BCM transport pointers
Configuring CPUTRANS TX
Configuring CPUTRANS RX
Instantiating /download as rawFs,
Formatting /download for DOSFS
Instantiating /download as rawFs, device = 0x20001
Formatting.../download: file system is marked clean, skipping check
OK.
<186> Apr 6 03:09:42 0.0.0.0-1 General[1073741072]: bootos.c(225) 1 %% Event(0xaaaaaaaa)
Instantiating RamCP: as rawFs,
Formatting RamCP: for DOSFS
Instantiating RamCP: as rawFs, device = 0x30001
RamCP:/
- disk check in progress ...
RamCP:/
- Volume is OK
OK.
(Unit 1 - Waiting to select management unit)>
Applying Global configuration, please wait ...
Applying Interface configuration, please wait ...
console>
6. After the switch has finished rebooting, log in and verify that the firmware has been updated to the
version using the show version command. A single switch will typically reboot in around two minutes. A
stack may take significantly longer to complete the upgrade process.
console#show version
System Description................ Dell Ethernet Switch
System Up Time.................... 0 days, 00h:02m:36s
System Contact....................
System Name.......................
System Location...................
Burned In MAC Address............. 5C26.0AB2.4327
System Object ID.................. 1.3.6.1.4.1.674.10895.3023
System Model ID................... PC8024
Machine Type...................... Powerconnect 8024
unit image1
---- ----------- ----------- -------------- --------------
1
4.2.1.3
7. The switch is now ready for normal operation. Verify the configuration and make any changes needed prior
to connecting the switch to the operational network.
NOTE:
After upgrading to the 5.1.9.3 firmware, one can emulate the earlier
firmware default behavior for privileged exec (enable) mode access by
setting the enable authentication method to enableList.
console(config)# line telnet
console(config)# enable authentication enableList
console(config)# exit
60
2
4
136
device = 0x20001
device = 0x30001
image2
current-active next-active
5.1.9.3
image2
image2
Page 7
5.1.9.3