- ページ 12

スイッチ Dell PowerConnect 8024FのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerConnect 8024F 21 ページ。 Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 8024F にも：リリースノート (27 ページ), リリースノート (20 ページ), 実施マニュアル (8 ページ), ファームウェアのアップグレード (24 ページ)

ページを印刷する

3.5

Check current operational mode

Note: Before proceeding, the "System Operational Mode" must be set to "Normal". Some switches, such

as the M8024k, ship from the factory in simple mode.

console>enable

console#configure

console(config)#no mode simple

Switching modes will immediately clear the configuration.

to continue? (y/n) y

Switch has unsaved changes.

Are you sure you want to continue? (y/n) y

Note: The switch will reboot. If the switch reports "Normal mode already active", then you may proceed

to the next step without rebooting.

3.6

Disable DCB

Note: The PowerConnect M8024-k switches do not support Enhanced Transmission Selection (ETS),

therefore Data Center Bridging (DCB) must be manually disabled using the following steps. If you have

the M8024 switch, skip this section.

console>enable

console#configure

console(config)#no dcb enable

3.7

Configure out of band (OOB) management port

console(config)#interface out-of-band

console(config-if)#ip address ipaddress mask gateway

console(config-if)#exit

3.8

Configure login credentials

console(config)#line telnet

console(config-telnet)#login authentication default

console(config-telnet)#exit

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs

Are you sure you want