- ページ 8
スイッチ Dell PowerConnect B-RXのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerConnect B-RX 32 ページ。 Powerconnect b-rx series
ページを印刷する
•
Eight-slot chassis
-
Up to two management modules (one active and one redundant).
-
Up to three switch fabric modules.
-
Up to eight interface modules.
-
Up to four power supplies (AC or DC).
•
16-slot chassis
-
Up to two management modules (one active and one redundant).
-
Up to four switch fabric modules.
-
Up to 16 interface modules.
-
Up to eight power supplies (AC or DC).
NOTE
Before installing any modules or power supplies, you must remove the slot blank or blank power supply faceplate,
respectively.
Site planning and safety guidelines
The following steps and safety precautions are required to ensure correct installation and operation.
Site planning
Follow these steps to ensure your site is ready for installation.
Cabling infrastructure
Ensure that the proper cabling is installed in the site.
For information on cabling, refer to
page 24, and
"Connecting the PowerConnect B-RX Series to a network device"
Installation location
Before installing the switch, plan its location and orientation relative to other devices and equipment. For cooling
purposes, allow a minimum of 15.24 cm (6 in.) of space between the sides, front, and the back of the chassis and
walls or other obstructions. If a chassis is installed within a perforated enclosure, the perforations must have
openings of at least 60 percent of the surface.
8
"Installing power supplies"
on page 20,
"Attaching a management station"
on page 31.
PowerConnect B-RX Series Getting Started Guide
on
53-1001682-03