- ページ 15

スイッチ Dell PowerConnect M8024-kのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerConnect M8024-k 21 ページ。 Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect M8024-k にも：リリースノート (27 ページ), ファームウェアのアップグレード (24 ページ)

ページを印刷する

Optional virtual stack configuration for 8024 and 8024F

Note: If you wish to use a virtual stack configuration instead of LAG, follow the instruction below instead

of section 2 or 3.

One advantage of stacked switches is that they can be managed as a single switch; however firmware

updates will update all members of the stack simultaneously and therefore should only be done during

planned downtime.

Do not connect the cables between the stacked switches (this will be done in a later step).

On both switches, enter the following commands:

4.1

Check firmware version

console>enable

console#show version

Note: If the active version displayed is not 5.1.1.7 or later, please visit support.dell.com and download the

latest update for your switches.

4.2

Delete startup configuration

Note: All configuration settings will be deleted

console#clear config

console>enable

console#copy running-config startup-config

console#reload

Are you sure you want to reload the stack? (y/n) y

Note: The switch will reboot.

On the first switch only, proceed with the following steps:

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs