- ページ 4

スピーカー AVX AVX-SAT6のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AVX AVX-SAT6 6 ページ。 70v / 100v / 8 ohm outdoor landscape speakers

INSTALLATION

Determining Loudspeaker Locations

Plan locations with no more than 25'-30' spacing between satellite speakers.

70/100 volt systems can be fine-tuned further using the wattage tap setting to determine the final volume

of each loudspeaker.

Landscape speakers should be installed at ground level using the included ground spikes.

Mounting Considerations

Clearance around the speaker is required for installing, connecting, and adjusting the angle of the sp eaker.

Care should be taken while selecting the mounting area so that the speakers do not become a trip hazard or

an obstacle for landscaping equipment.

Avoid locations where lawn irrigation sprinklers might spray water directly into the loudspeaker.

The loudspeakers will not be damaged by normal rainfall, but spraying water directly into the

speakers may cause damage.

Loudspeaker Mounting and Angle Adjustments

A. Pan

The pan adjustment of the loudspeaker allows for left to right alignment of sound coverage. This is adjusted

using the mounting base threads. After attaching the loudspeaker to a compatible mounting accessory,

route the makeup lead wires on the speaker into the mounting device, and then thread the speaker base

in, leaving about 1/2 turn of play to allow for final adjustment. After the loudspeaker is installed and

positioned correctly, tighten it securely into place.

B. Tilt

The tilt mechanism permits vertical adjustment of sound coverage. Adjust the angle of the speaker by

loosening the Phillips set screw on the pivot bracket as illustrated. Once the desired position is

achieved, re-tighten the screw.