- ページ 25

スイッチ Dell PowerEdge M620のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge M620 26 ページ。 Dell poweredge blade servers getting started guide
Dell PowerEdge M620 にも：情報更新 (38 ページ), リリースノート (27 ページ), マニュアル (25 ページ), ユーザーマニュアル (23 ページ), 重要事項説明書 (35 ページ), 更新マニュアル (32 ページ), 更新マニュアル (28 ページ), ユーザーマニュアル (22 ページ), スタートマニュアル (12 ページ), スタートマニュアル (12 ページ), テクニカル・マニュアル (46 ページ), テクニカル・マニュアル (49 ページ), ポートフォリオ・マニュアル (27 ページ), テクニカル・マニュアル (44 ページ), スタートマニュアル (14 ページ), スタートマニュアル (12 ページ)

ページを印刷する

Dell 10Gb Ethernet Pass Through II

Troubleshooting

This section provides troubleshooting information for common error conditions. If the described

procedure does not solve the problem, please contact your Dell representative for assistance.

Please use the following table to identify the required correctional operation:

Error Condition

10GbE PTM power LED does not turn on See

Downlink connection to a blade server

does not come up

Uplink connection to remote switch does

not come up

Unable to connect to 10GbE PTM10GbE

PTM CLI

10GbE PTM CLI hangs during operation See

10GbE PTM software update procedure

fails

5.1

Resolving 10GbE PTM Power Problems

Make sure the system is powered on.

Take out the 10GbE PTM, wait for 10 seconds and plug it back in.

5.2

Resolving Link Connectivity Problems

1. Check that external cables and/or optical modules are properly inserted.

2. Make sure the cables/modules are supported by the 10GbE PTM.

3. Log in to 10GbE PTM CLI and run the "show port link" command. Check the status of the

downlink and uplink in the relevant port – see

a. If a blade is inserted but not recognized by the 10GbE PTM – restart the network device in the

blade and check again. Reboot the blade if the problem is not resolved.

b. If an Ethernet NIC or switch is connected to an 10GbE PTM external port but the link is down for the

10GbE PTM external port – check cables/modules connectivity in the external device and reboot the

external device if not resolved.

If none of the above resolves the issue – reboot the 10GbE PTM through the CMC CLI using the

following command:

Table 6 - Error Conditions and Correctional Operation

Section 5.1, "Resolving 10GbE PTM Power Problems," on

page 25

Section 5.2, "Resolving Link Connectivity Problems," on

See

page 25

Section 5.2, "Resolving Link Connectivity Problems," on

See

page 25

Section 5.4, "Resolving CLI Connectivity Problems," on

See

page 26

Section 5.5, "Recovery From Non-Responsive 10GbE PTM

CLI," on page 26

Section 5.6, "Recovery From a Software Update Failure," on

See

page 26

Correctional Operation

Section 3.7.1

for details.

Rev 1.00