- ページ 21
スイッチ Dell PowerEdge XL 5133-4のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge XL 5133-4 38 ページ。 Dell poweredge m i/o aggregator getting started guide
ページを印刷するInvoking the X-Loader and U-Boot CLIs
During the boot process, you can perform various configuration tasks by
accessing the X-Loader and U-Boot CLIs, such as running memory tests
(X-Loader) and activating the backup image or recovering a password
(U-Boot).
You are first prompted to enter the X-Loader CLI by pressing any key when
the following message is displayed: Hit any key to stop autoboot.
If you do not press a key, the boot process continues and you are prompted to
enter the U-Boot CLI by pressing any key.
After performing any of the X-Loader or U-Boot tasks, the switch
automatically reboots when you exit a CLI. To continue with the boot process
without entering either CLI, do not press a key.
Reconfiguring Default Settings
The I/O Aggregator provides zero-touch configuration with:
•
default user name (root)
•
password (calvin)
•
VLAN (vlan1) and IP address for in-band management (DHCP)
•
IP address for out-of-band (OOB) management (DHCP)
•
read-only SNMP community name (public)
•
broadcast storm control (enabled)
•
IGMP multicast flooding (enabled)
•
VLAN configuration (all ports belong to all VLANs)
You can change any of these default settings using the CLI. You can change
many of the default settings using the CMC interface as described in
"Reconfiguration Using the CLI" on page 22.
Installing and Configuring the Aggregator
21