- ページ 16

スイッチ Dell S4048-ONのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell S4048-ON 19 ページ。 Enterprise switches
Dell S4048-ON にも：設定マニュアル (30 ページ), トラブルシューティングマニュアル (29 ページ)

ページを印刷する

System configuration has been modified. Save? [yes/no]no

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

5.4

Configure stack on the second switch

Dell>enable

Dell#stack-unit 1 renumber 2

Note: After confiming configuration change, the switch will need to reboot.

Dell#configure

Dell(conf)#stack-unit 2 priority 1

Dell(conf)#stack-unit 2 stack-group 12

Dell(conf)#stack-unit 2 stack-group 13

Dell(conf)#exit

Dell#copy running-config startup-config

Dell#reload

5.5

Verify stack configuration

From the first switch (Master) CLI, confirm that the stack has formed:

Dell#show redundancy

Dell#show boot system stack-unit all

Note: The MASTER LED on the switch front panel will show a steady light for the master unit and a

blinking light for the standby unit. All of the following configuration steps must be performed from the

master switch.

5.6

Configure out of band (OOB) management port

Dell#config

Dell(conf)#interface ManagementEthernet 1/1

Dell(conf-if-ma-1/1)#no shutdown

Dell(conf-if-ma-1/1)#ip address ipaddress mask

Dell(conf-if-ma-1/1)#no shutdown

Dell(conf-if-ma-1/1)#exit

SCG1026

Dell Networking S4048-ON Switch Configuration Guide for PS Series SANs