- ページ 19

スイッチ Dell S4048-ONのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell S4048-ON 30 ページ。 Enterprise switches
Dell S4048-ON にも：設定マニュアル (19 ページ), トラブルシューティングマニュアル (29 ページ)

ページを印刷する

Switch configuration (OS 10.x)

3.1.3

Delete startup configuration

Note: The following commands will delete all configuration settings.

OS10# delete startup-configuration

Proceed to delete startup-config [confirm yes/no(default)]yes

OS10# reload

System configuration has been modified. Save? [yes/no]no

Proceed to reboot the system? [confirm yes/no]yes

Note: The switch will reboot.

3.1.4

Configure out of band (OOB) management port

After the startup configuration is deleted, the factory default password is admin.

OS10# configure terminal

OS10(config)# interface mgmt 1/1/1

OS10(conf-if-ma-1/1/1)# no ip address dhcp

OS10(conf-if-ma-1/1/1)# ip address <ipaddress>/<subnet>

OS10(conf-if-ma-1/1/1)# exit

OS10(config)#

3.1.5

Configure login credentials

OS10(config)# username admin password $0$<password>

3.1.6

Configure QSPF ports to 4 x 10GbE breakout ports

QSFP ports can be configured as breakouts to be used with 10GbE iSCSI storage or server network

adapters. To configure these ports as 4 x 10GbE ports, use the following commands.

OS10(config)# interface breakout 1/1/<port-number> map 10g-4x

OS10(config)# exit

OS10#

Use the following command to check port interface status.

OS10# show interface status

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026