ページを印刷する
2
RJ-45 management port
NOTE:
You must have a password configured on a virtual terminal line before you
can Telnet into the S4048T–ON system. Therefore, use a console connection when
connecting to the system for the first time. Before starting this procedure, be sure
that you have a terminal emulation program already installed on your PC.
1
Install an RJ-45 copper cable into the console port.
Use a rollover cable to connect the S4048T–ON console port to a terminal server.
2
Connect the other end of the cable to the DTE terminal server.
3
Set the default terminal settings as follows:
•
115200-baud rate—set the Micro USB console port to the same rate
•
No parity
•
Eight data bits
•
One stop bit
•
No flow control
RJ-45 console port access
You can connect to the console using an RJ-45 to RJ-45 rollover cable and an RJ-45 to
DB-9 female DTE adapter to a terminal server; for example, a PC.
The pin assignments between the console and a DTE terminal server are as follows:
Table 1. Pin assignments between the console and a DTE terminal server
S4048T-ON
console port
Signal
NC
NC
TxD
GND
GND
RxD
RJ-45 to RJ-45
rollover cable
RJ-45 Pinout
1
2
3
4
5
6
RJ-45 to RJ-45
rollover cable
RJ-45 Pinout
8
7
6
5
4
3
RJ-45 to DB-9
adapter
DB-9 Pin
8
6
2
5
5
3
Software configuration
Terminal server
device
Signal
CTS
DSR
RxD
GND
GND
TxD
27