- ページ 7
プリンター Dell 540 - USB Photo Printer 540のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Dell 540 - USB Photo Printer 540 37 ページ。 Dell™ photo printer 540 user's guide
Dell 540 - USB Photo Printer 540 にも： 仕様 (2 ページ), ユーザーマニュアル (43 ページ)
ページを印刷する
Back to Contents Page
Replacing the Battery
Dell Studio™ 540 Service Manual
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.
1. Record all the screens in system setup (see
2. Follow the procedures in
Before You
3. Remove the computer cover (see
4. Locate the battery socket (see
NOTICE:
If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is
inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off
the socket or by breaking circuit traces on the system board.
1 battery (positive side) 2 battery release lever
5. Carefully press the battery release lever away from the battery and the battery will pop out.
6. Remove the battery from the system and properly dispose of the battery.
7. Insert the new battery into the socket with the side labeled "+" facing up, then snap the battery into place.
1 battery (positive side) 2 battery release lever
8. Replace the computer cover (see
9. Connect your computer and devices to electrical outlets, and then turn them on.
10. Enter system setup (see
System
Back to Contents Page
System
Setup) so that you can restore the correct settings in
Begin.
Replacing the Computer
Cover).
System Board
Components).
Replacing the Computer
Cover).
Setup) and restore the settings you recorded in
step
10.
step
1.