- ページ 5

電動歯ブラシ 30 Second Smile TSS300のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。30 Second Smile TSS300 10 ページ。

ページを印刷する

INSTALLING BRUSH HEADS

Note: A brush head consists of two halves of matching brushes.

Install brush heads back to back, one at a time, with bristles facing outward or

away from each other. Align and push brushes onto metal pin until it snaps into

place. NOTE: The tips of the metal pins are never aligned. Depending on where

the brush starts/stops, one pin will always be longer than the other.

confirm brush head is installed by gently

pulling on the brush head

BRUSH HEAD REMOVAL

Remove brush heads, one at a time, by pushing the release button, located on the

side of the brush, and pull away from the toothbrush handle to remove. Repeat

with second brush head.

push the button

and pull

Brush heads should be replaced every 60-90 days.

Order replacement brush heads at www.30secondsmile.com or call

(800) 431-1902

BRUSHING INSTRUCTIONS

FOR ADULTS

For the first several weeks, use the RED ULTRA-Soft brush head at Speed 1. Use

Speed I by pressing the Power Button once. After your gums become accustomed to

your 30 Second Smile

toothbrush, you can switch to the BLUE Standard brush head

and adjust to Speed II by pressing the Power Button twice, which is even more

effective in plaque removal and gum stimulation.

FOR CHILDREN

It is recommended to use the KIDS RED ULTRA -Soft brush head at Speed I.

You may experience minor bleeding. This is normal, and is an indication that the 30

Second Smile

toothbrush is now brushing areas of the gums that were not reached

with other brushes.

Be sure brush head does not bump teeth. For proper use of brush see brushing

instructions on page 8. Children under the age of 5 should not use the 30 Second

toothbrush unsupuervised. The built-in 30 Second Smile

Smile

programmed to remind you to only brush 15 seconds on each side of the mouth for

perfectly clean teeth and gums.

REFER TO THESE FOLLOWING STEPS:



Wet bristles and apply a pea-size amount of toothpaste to both sets of

bristles, if desired.

place toothpaste on both sides



Before putting the brush in your mouth, turn it

on by pressing the Power Button. Press once for

Speed I (LOW speed) and twice for Speed II (HIGH

speed). Once the Power Button is pressed, the LED

light will light up. One light indicates the unit is

on Speed I, two lights indicates the unit is on

Speed II.

timer is