- ページ 5

アンプ EarthQuake PH10000W/D1のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。EarthQuake PH10000W/D1 10 ページ。 Powerhouse series amplifiers
EarthQuake PH10000W/D1 にも：パンフレット (8 ページ), オーナーズマニュアル (11 ページ), オーナーズマニュアル (10 ページ)

ページを印刷する

PH1000W/2

+18dB boost @ 45Hz

+12dB boost @

designed to shape/

12kHz essential

boost the response

boost for high-pass

curve in a low-pass

ampliﬁer applications

mode application.

SPEAKER

CH1

CH2

MONO

Speaker

Outputs

Minimum 4 Ohm Mono

Speciﬁcations Are Subject To Change Without Notice

3-way switch

RCA level inputs, with

runs the amp

a range of 0.2V to 5V.

in low-pass,

RMS.

full-range or

high-pass

3-way switch feeds RCA

mode.

outputs a low-pass full-

range or high pass signal.

Crossed

RCA level

outputs, can be used

to feed other ampliﬁers

in the system.

The gain knob is not a volume control.

It is designed to match the input level

of the amp to the output level of the

source unit. Over driving -clipping- the

input stage of the amp will cause

damage to the ampliﬁer (Please refer

to table for settings).

BAT

REM GND

FUSE

POWER

Born In The USA

To car chassis / ground

30A Fuse

To remote turn on / trigger

To battery (+)

The PH1000W/2 is designed to

operate in stereo or mono mode. When

used in stereo applications, a minimum

load of 2 ohms per channel is required.

Set Xover knob to

Minimum (20Hz), &

set Xover switch to

Full Range

FC6.2

Tweeter

FC6.2 Midrange

The PH1000W/2 is designed to

operate in mono mode. When

bridging the two channels, a

minimum load of 4-ohms is

required.