ページを印刷する
The following rules must be strictly followed to obtain optimal air
extraction:
Do not install above a cooker with a high level grill.
Important! Always switch off the electricity supply at the mains
during installation and maintenance.
The range hood must be installed in accordance with the
installation instructions and all measurements followed.
Please dispose of the packing material carefully. It may be a risk to
children.
Pay attention to the sharp edges inside the range hood especially
during installation and cleaning.
When the range hood is located above a gas appliance, the
minimum distance between the supporting surface for the cooking
vessels on the hob and the lowest part of the range hood that
distance must be:
Gas cookers:
Electric cookers:
Coal or oil cookers:
Make sure the ducting has no bends less than 120º as this will
reduce the efficiency of the range hood.
Warning: Failure to install the screws or fixing device in
accordance with these instructions may result in electrical hazards
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Warning: Before obtaining access to terminals, all supply circuits
must be disconnected.
For safety reason, please use only the same size of fixing or
mounting screw which are recommended in this instruction manual.
When the range hood and appliances supplied with energy other
than electricity are simultaneously in operation, the negative
pressure in the room must not exceed 4 Pa (4 x 10-5 bar).
Keep ducting pipe short and straight.
Do not reduce the size or restrict ducting pipe.
When using ducting pipe always install the pipe pulled taut to
minimize pressure loss.
Failure to observe these basic instructions will reduce the
performance and increase noise levels of the range hood.
Any installation work must be carried out by a qualified electrician
or competent person.
(4) NOTICE OF INSTALLATION
75cm
65 cm
75 cm
4