- ページ 4

スプレッダー EarthWay 2170のPDF 組立・取扱説明書をオンラインで閲覧またはダウンロードできます。EarthWay 2170 6 ページ。 Commercial broadcast spreader with side spread control
EarthWay 2170 にも：組立・取扱説明書 (6 ページ), 組立・取扱説明書 (8 ページ), 取扱説明書 (8 ページ), 組立説明書 (12 ページ), 組立説明書 (10 ページ)

ページを印刷する

13. Install handle shaft to lower handles and pivot & bracket assembly as shown. Using 1/4 -20 x 2" bolts and

locknuts. TIGHTEN BOLTS AND NUTS NOW.

Holes are farther

Gauge & Lever

Lever Tensioning Nut

15. Install flattened end of control rod in to lever on gauge as shown. Turn to lock in place. Next push lever forward to setting "0". Align

control rod with hole in pivot bracket, pull lever backward to insert control rod through hole in pivot bracket. Now install 1/4-20 Hex nut on

to control rod.

16. Pull lever back to setting "30" as shown. Next push pivot & bracket forward so that the shut off plate in the hopper is in the full open

position. REMEMBER SETTING "30" ON THE FLOW CONTROL LEVER MUST PLACE THE SHUT-OFF PLATE IN THE FULL

OPEN POSITION TO BE PROPERLY CALIBRATED. Now tighten the nuts against the pivot bracket to prevent change in calibration.

17. Tension on the flow control lever may be adjusted by tightening or loosening the tension nut as shown.

18. Insert agitator to pinion shaft on inside of hopper.

Note: the position of flat side of the agitator. This pin

should be installed as shown.

PAGE 4

1/4 - 20 Lock-nut

Pivot Bracket

1/4 - 20 x 2" Bolt

Long End

from one end

Control Rod

Tabbed Hole

Control Rod

Handle Shaft

1/4-20 x 1"

Hex Head Bolt

Stainless

19. Install debris screen into hopper, then insert 1/4-20 x 1"

Stainless Steel Hex Bolt thru the hole in the side wall of the hopper.

Secure with Stainless Steel lock nut - TIGHTEN WITH HAND

TOOLS ONLY

14. Install (1) 1/4-20 Hex

nut (not a locknut) on to

control rod as shown.

1/4-20

Hex Nuts

Pivot

Control

Bracket

Rod

1/4-20 Lock Nut

Stainless