- ページ 4

スプレッダー EarthWay 2170TのPDF 組立・取扱説明書をオンラインで閲覧またはダウンロードできます。EarthWay 2170T 6 ページ。 Commercial tow broadcast spreader
EarthWay 2170T にも：組立・取扱説明書 (6 ページ)

Gauge & Lever

Lever Tension Nut

15. Install flattened end of control rod in to lever on gauge as shown. Turn to lock in

place. Next push lever forward to setting "0". Align control rod with hole in pivot

bracket, pull lever backward to insert control rod through hole in pivot bracket. Now

install 1/4-20 regular nut on to control rod.

16. Pull lever back to setting "30" as shown. Next push pivot & bracket forward

so that the shut off plate in the hopper is in the full open position. REMEMBER

SETTING "30" ON THE FLOW CONTROL LEVER MUST PLACE THE

SHUT-OFF PLATE IN THE FULL OPEN POSITION TO BE PROPERLY

CALIBRATED. Now tighten the nuts against the pivot bracket to prevent change in

calibration.

17. Tension on the flow control lever may be adjusted by tightening or loosening the

tension nut as shown.

18. Insert agitator to pinion shaft on inside of hopper.

Note: the position of flat side of the agitator. This pin

should be installed as shown.

19. Install debris screen into hopper, then insert

1/4-20 x 1" Stainless Steel Hex Bolt thru the hole in

the side wall of the hopper. Secure with Stainless

Steel lock nut - TIGHTEN WITH HAND TOOLS

ONLY

PAGE 4

Control Rod

Tabbed Hole

Control Rod

1/4-20 x 1"

Hex Head Bolt

Stainless

14. Install (1) 1/4-20 regular nut (not a locknut)

on to control rod as shown.

Pivot

Bracket

1/4-20

Regular Nuts

Control

Rod

1/4-20 Lock Nut

Stainless