- ページ 18
防犯カメラ 360 Vision VisionDome VRのPDF インストール＆設定マニュアルをオンラインで閲覧またはダウンロードできます。360 Vision VisionDome VR 20 ページ。
ページを印刷する
Vision i Dome_VisionDome VR Installation Manual Ver 3.1
General 1
•
Digital Zoom - Use this option to enable or disable digital zoom.
•
White Balance - Change the camera white balance settings to suit the area.
•
Line Lock - (Not available on Vision i Dome) Used to line lock the camera.
•
Line Phase - (Not available on Vision i Dome) Can be used to manually adjust the line phase.
•
Video Gain - (Not available on Vision i Dome) Used to adjust the video level to suit different lengths of
coax cable.
•
Video Lift - (Not available on Vision i Dome) Used to adjust the frequency of the video level to suit
different lengths of coax cable.
•
Wide Dynamic - (Not available on Vision i Dome) Enable WDR. Options available are ON, Auto and
Off. Default is off.
General 2
•
Auto Flip - Use this option to set how the camera behaves when full tilt down is reached.
Semi - Requires a second tilt down command, when at full tilt down to spin camera 180°.
Full - Automatically spins the camera 180°
•
Proportional - Automatically reduces/increases pan/tilt speed depending on zoom ratio.
•
Freeze Presets - (Not available on Vision i Dome) This option freezes the image, when moving
between presets.
•
Zoom Speed - Use to set preferred zoom speed, 5 is slow and 8 is fast.
•
OSD Preset Six - Go into OSD using preset 95 and you can switch off OSD access using preset 6.
•
AF AI When PTZ - Auto focus/iris will activate when PTZ is used, can be switched off. Default is on.
Night (Not available on Vision i Dome)
•
Col/Mono Change - Col/Mono level settings can be changed to suit the site requirements. Options
are dark, medium and light. Default is dark. This sets when the camera goes into 'mono mode'.
•
Mono On - Range is 7 to 25. A lower value will set the level on when the scene is brighter, a higher
value will set the level on when the scene is darker.
•
Mono Off - Range is 1 to 20. A lower value will set the level off when the scene is brighter, a higher
value will set the level off when the scene is darker.
•
Bright Control - Options are automatic or normal.
•
Noise Reduction - Used to reduce noise with scenes of low illumination. NR must be set to suit the
environment. Default is off.
•
Aperture - Can be used to increase the picture detail. Default is 3.
Shutter
•
Fast Shutter - Option to enable fast shutter and set speed of the shutter.
•
Slow Shutter - Option to alter the slow shutter speed. Altering this figure will have an effect on the low
light capabilities of the camera.
Text Field Menu (Not available on Vision i Dome)
Navigate along alpha-numeric characters and use zoom in to select. Choose text position by inputting x and y
co-ordinates. Set text display to on, if required.
Servicing
•
Power Reset - This will reboot the camera, no settings will be lost.
•
Factory Reset - This will reboot the camera and all the settings will be lost.
•
Dome Software Version - This shows the software version of the camera.
© 360 Vision Technology Ltd.
Page 18