- ページ 19
食器洗い機 Miele G 1202のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Miele G 1202 46 ページ。
Miele G 1202 にも： マニュアル (14 ページ)
ページを印刷するG 1xxx/G 2xxx
Function
Second interim rinse (ID
nos. -984 and later)
Extended drying time
Appliance height setting
Model setting
Country setting
Table 11: Service Programming Mode, G 1470/G 2470
1
In machines with software version -876, run the update "Optimized cleaning of tea
residues in Sensor Wash program" (mat. no. 06471560). Modified threshold values will
improve the cleaning outcome.
2
If the electronic needs to be replaced during servicing, the following steps must be taken
during programming: In the first step, set the country specification and model, then switch
off the appliance. Repeat access and then set appliance width and height, and the
appropriate supply water hardness.
3
The SER country specification includes the following countries: Portugal, France, the
Netherlands, Belgium and Great Britain.
Save and quit:
Switch off the appliance.
Programming
Press the GEL button 26x.
The "GEL" LED flashes 2x
slowly and 6x quickly
intermittently. Press the
Program button as
appropriate to make the
desired setting.
Press the GEL button 27x.
The "GEL" LED flashes 2x
slowly and 7x quickly
intermittently. Press the
Program button as
appropriate to make the
desired setting.
Press the GEL button 36x.
The "GEL" LED flashes 3x
slowly and 6x quickly
2
intermittently. Press the
Program button as
appropriate to make the
desired setting.
Press the GEL button 38x.
The "GEL" LED flashes 3x
slowly and 8x quickly
2
intermittently. Press the
Program button as
appropriate to make the
desired setting.
Press the GEL button 39x.
The "GEL" LED flashes 3x
slowly and 9x quickly
2
intermittently. Press the
Program button as
appropriate to make the
desired setting.
19
Technical Information
Display
The display shows p and a digit
alternately. Setting options: p0 =
Standard setting; p1 = With second
interim rinse.
The display shows p and a digit
alternately. Setting options: p0 =
Normal drying time; p1 = Extended
drying time (+10 mins).
The display shows p and a digit
alternately. Setting options:
p0 = Normal machine height (G
1xxx); p1 = XXL model (G 2xxx).
The display shows p and a digit
alternately. Setting depends on
model and whether a circulation
pump with slide shutter (WAW) and
sensor softener (SEH) are installed.
p3 = G14xx, G24xx (w/out WAW,
w/SEH).
The display shows p and a digit
alternately. The following countries
can be set: p1 = EUR (Europe); p2 =
AUS (Australia); p3 = USA; p4 =
JPN (Japan); p5 = I/E (Italy/Spain);
p6 = SER (Southern Europe).
3