- ページ 12

ゲートオープナー Allmatic HYPER 600のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Allmatic HYPER 600 16 ページ。 Ambidextrous irreversible operator for swing door gates

6.2 DETERMINE THE INSTALLATION MEASUREMENTS (OUTWARD OPENING)

Before fixing the supplied brackets it is necessary to determine the installation dimensions A and B.

Start by putting the gate in position of "OPEN DOOR".

Choose the sizes of A and B from Tables 7 and 8 of the previous paragraph, according to your installation and in order to obtain

the desired degree of opening "α". This grade shown in the table refers to the highest possible degree of openness with the

corresponding dimensions.

For the anchor of the piston it is necessary to use additional supports (not supplied) together with the fixing brackets supplied. These

supports shall be appropriate to the dimension of the door and the pillar.

ATTENTION!

With respect to the type of installation described in the previous paragraph, the measurements of A and B are

inverted in position (SEE FIGURE BELOW).

The support drawn in the following figure, to which the rear bracket is connected is only an example for expla-

natory purposes.

With this type of installation, the automations protrude and then reduce the width of the passage.

TOP VIEW

ADDITIONAL SUPPORT

(NOT PROVIDED)

12 / 16

ENG

EXTERNAL SIDE

OF THE PROPERTY

INTERNAL SIDE OF

THE PROPERTY

6-1624982 - rev.1 - 20/05/2021