- ページ 32

換気フード Miele DA 2390のPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。Miele DA 2390 36 ページ。 Ventilation system
Miele DA 2390 にも：操作およびインストール手順 (40 ページ), 操作およびインストール手順 (40 ページ), 操作およびインストール手順 (36 ページ), 操作およびインストール手順 (40 ページ), 操作およびインストール手順 (36 ページ)

ページを印刷する

Installation

If the on-site vent system does not have

a non-return flap, one is supplied with

the ventilation hood.

The non-return flap is installed in the

exhaust socket of the fan.

Condensate

If the ducting is to run through cool

rooms or ceiling space, for example, the

significant variations in temperature

between the different areas can cause

condensate to form. Insulate the ducting

to reduce temperature variations.

If the ducting is to be laid horizontally, it

must be laid with a downwards sloping

gradient of at least ³/₈" (1 cm) per meter.

This is to ensure that condensate

cannot drain back into the ventilation

hood.

In addition to insulating the ducting, it is

advisable to also install a condensate

trap for collecting and evaporating any

potential condensate.

Condensate traps for 5" (125 mm) or

6" (150 mm) diameter ducting are

available as optional accessories.

When installing a condensate trap,

ensure that it is positioned vertically

and as closely as possible to the

ventilation hood above the exhaust

vent. The arrow on the casing indicates

the direction of airflow.

Miele will not accept warranty claims

for any functional defects or damage

caused by inadequate ducting.

Reducing Collar

(optional accessory)

If you would like to reduce the

environmental impact of your ventilation

system by limiting the CFM output the

Reducing Collar can be installed. It

reduces the air flow to less than

400 CFM. Check local building codes

for max. CFM requirements.

 Push the Reducing Collar on the

exhaust port of the blower.

 Push the exhaust hose over it.

 Secure both with a hose clamp.