- ページ 26

換気フード Miele DA 252-4のPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。Miele DA 252-4 36 ページ。 Cooker
Miele DA 252-4 にも：操作およびインストール手順 (36 ページ)

ページを印刷する

Plywood backing

The majority of the weight of the

installed ventilation system will be

supported by the canopy. Its

mounting bracket must be firmly

attached to the stud framing behind

the drywall. If studs are not located

in the required locations, a plywood

backing (min.

spanning at least two studs must be

installed. Failure to adequately

support the weight as stated may

result in the ventilation system falling

off the wall, causing personal injury

and property damage.

(If plywood backing is not needed,

proceed to "Appliance dimensions and

Installation").

To install a plywood backing board

^ Determine and mark the location of

the retaining plate for the canopy as

outlined on the Installation sheet.

^ Make a cutting line 3" (76 mm) above

and 3" (76 mm) below the outline of

the retaining plate.

" (13 mm) thick)

^ Find the studs to the left and right of

the mounting location by tapping the

wall or using a stud finder.

^ Mark the center of each of the studs

with a vertical line.

Be careful not to damage any wiring

or plumbing that may be located

behind the wall. Make sure that the

power supply to the area being

worked in has been turned off at the

breaker panel before cutting into the

wall.

^ Cut out the drywall along the marked

lines and replace it with plywood of a

matching thickness (min.

thick). Tape the joints and refinish the

wall.

^ See enclosed installation sheet for

instructions on how to install the

appliance.

" (13 mm)