- ページ 4

ゲートオープナー Allmatic PLUS LのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Allmatic PLUS L 10 ページ。 Irreversible operator for leaf gates

ページを印刷する

INSTALLATION

PRE-INSTALLATION CHECKS

The leaf must be fixed firmily on the hinges to the pillars, must not be flexible during the

movement and must move without frictions.

Before the installation of PLUS, verify all dimensions etc.

There's no need for any modification, if the gate is like that shown in Fig. 1.

Gate features must be uniformed with the standards and laws in force. The gate

can be automated only if it is in a good condition and its conditions comply with the EN

12604 norm.

- The gate leaf does not have to have a pedestrian opening. In the opposite case it

is necessary to take the appropriate steps, in accordance with EN 12453 norm (for

instance; by preventing the operation of the motor when the pedestrian opening is

opened, by installing a safety microswitch connected with the control panel).

- No mechanical stop shall be on top of the gate, since mechanical stops are not safe

enough.

FIXING THE ACTUATOR ATTACHMENT TO THE COLUMN

To obtain a correct movement of the leaf gate it is necessary to respect the measures (to

see the TABLES of the measures).

COLUMN ATTACHMENT FOR PLUS OPERATOR

If the column is in iron, the attack can be screwed directly using four metric screws M8.

If the column is in concrete, the attack can be fixed with four expansion screws Ø 8

mm (Fig. 2-3).

In the case you have a wall parallel with the open gate, you must provide a niche in which

to place the operator.

COLUMN ATTACHMENT FOR PLUS L OPERATOR

To obtain a correct movement of the leaf gate it is necessary to respect the measures.

If there is an iron pillar you can weld the attachment directly.

If there is a cement pillar, you can use the fixing plate as in Fig. 5 which is fastened with

4 Fischer-screws of Ø 8 mm.

There is also the possibility to cement the attachment welding an anchor at its base

Fig. 6.

Naturally you have to respect predetermined fixing measures.

Afterwards you must weld the other actuator's attachment to the gate (Fig. 8).

In the case you have a wall parallel with the open gate, you must provide a niche in which

to place the operator.

6-1624020 rev. 14 21/07/2016

www.remotecontrolgates.co.uk

Parts to install meeting the EN 12453 standard

Skilled persons

COMMAND TYPE

(out of public

area*)

with manned

operation

with visible impulses

C or E

(e.g. sensor)

with

not

visible

impulses

C or E

(e.g. remote control

device)

automatic

C and D, or E

* a typical example are those shutters which do not have access to any public way

A: Command button with manned operation (that is, operating as long as activated)

B: Key selector with manned operation

C: Adjustable power of the motor

D: Safety strips and/or other safety devices to keep thrust force within the limits of

EN12453 regulation - Appendix A.

E: Photocells (To apply every 60÷70cm for all the height of the column of the gate up

to a maximum of 2,5m - EN 12445 point 7.3.2.1)

01482 860950

USE OF THE SHUTTER

Skilled persons

Unrestricted use

(public area)

non possibile

C or E

C and D, or E