ページを印刷する
Problem solving guide
Fault messages
Indicator / display
N 0
N W
Other messages
In the event of any faults please contact your Dealer or the nearest Service Department.
When contacting the Service Department, please quote the Model,
Serial number (Fabr.Nr) and Material number (M.Nr) of your machine.
These are shown on the data plate.
The data plate is located at the top of the door aperture with
the door open or at the top of the rear of the machine.
18
Possible cause
Over-pressure in vent ducting.
Leaks in the airways.
Fluff filter blocked
Gas burner malfunction
Peak load cut-out
The dryer will continue to run without
heating (cold) for the remainder of the
programme.
Remedy
Check the vent ducting.
Call the Service Department.
Clean the fluff filter.
Press the START/STOP button.
If the peak load cut-out is overridden, the
programme will continue as normal.