- ページ 4

デスクトップ HP 1850R - ProLiant - 128 MB RAMのPDF 概要をオンラインで閲覧またはダウンロードできます。HP 1850R - ProLiant - 128 MB RAM 20 ページ。 Proliant essentials foundation pack installation guide
HP 1850R - ProLiant - 128 MB RAM にも：実施マニュアル (35 ページ), エラー防止マニュアル (12 ページ), テクニカル・ホワイトペーパー (12 ページ), ファームウェア・アップデート (9 ページ), インストレーション・マニュアル (2 ページ)

are many mechanisms to refresh DRAM, including RAS only refresh, CAS before RAS (CBR) refresh,

and Hidden refresh. CBR, which involves driving CAS active before driving RAS active, is used most

often.

Figure 2. Representation of a write operation for FPM or EDO RAM

DRAM storage density and power consumption

The storage capacity (density) of DRAM is inversely proportional to the cell geometry. In other words,

storage density increases as cell geometry shrinks. Over the past few years, improvements in DRAM

storage density have increased capacity from almost 1 kilobit (Kb) per chip to 2 gigabit (Gb) per

chip. In the near future, it is expected that capacity will increase even further to 4 Gb per chip.

The industry-standard operating voltage for computer memory components was originally at 5 volts.

However, as cell geometries decreased, memory circuitry became smaller and more sensitive.

Likewise, the industry-standard operating voltage has decreased. Today, computer memory

components operate at 1.8 volts, which allows them to run faster and consume less power.

The length of time it takes for DRAM to produce the data, from the CAS signal until the data is

available on the data bus, is called the memory access time or CAS Latency. Memory access time is

measured in billionths of a second (nanoseconds, ns) for asynchronous DRAM. For synchronous

DRAM, the time is converted to number of memory bus clocks.

All computer components that execute instructions or transfer data are controlled by a system bus

clock. The system chipset controls the speed, or frequency, of the system bus clock and thus regulates

the traffic between the processor, main memory, PCI bus, and other peripheral buses.

The bus clock is an electronic signal that alternates between two voltages (designated as "0" and "1"

in Figure 3) at a specific frequency. The bus frequency is measured in millions of cycles per second,

or megahertz (MHz). During each clock cycle, the voltage signal transitions from "0" to "1" and back

to "0". A complete clock cycle is measured from one rising edge to the next rising edge. Data transfer

along the memory bus can be triggered on either the rising edge or falling edge of the clock signal.