- ページ 18

デスクトップ HP 3000 SeriesのPDF アップグレードマニュアルをオンラインで閲覧またはダウンロードできます。HP 3000 Series 19 ページ。 9x9 to k class conversion
HP 3000 Series にも：マニュアル (25 ページ), マニュアル (20 ページ), インストレーション・マニュアル (42 ページ)

ページを印刷する

CPU Warning Messages

There are two possible CPU warning messages that may be displayed, they are as follows:

A Processor has failed selftest and has been deconfigured. Refer to

the PR command in the INFORMATION menu for a list of deconfigured

processors.

If this message is displayed, perform the following steps:

1. Turn the key switch to the STANDBY position.

2. Turn the key to the ON position

3. See if the same sequence happens again. Do you get the same warning message? Do you get the same

four digit code displayed on the front panel?

4. If the answers to the questions in step 3 are YES, you probably have a CPU failure. Call your local

Hewlett-Packard representative for maintenance.

5. If the answers to the questions in step 3 are NO, but the computer still will not boot, you may have an

installation or CPU card seating problem. The CPU card needs to be taken out and re-installed. If that

does not correct the problem, call your local Hewlett- Packard representative for maintenance.

Processors are not installed in numerical order (0 to 3). Boot process

has been halted. Refer to PR command in the INFORMATION menu for

processor configuration information.

If this message is displayed, you may have skipped a CPU slot when installing a CPU card. Use the

Installation Verification procedures to check for proper installation sequence. If the sequence is not

correct, remove and reinstall the appropriate cards to achieve sequential order.

CPU Upgrade

CPU Warning Messages